How to Guide

TECHNICAL DATA
RESTORE
®
DECK START WOOD PRIMER
2 Form: GDH-692
Rev.: 042815
PRODUCT APPLICATION (cont) .
PRECAUTIONS & TEMPERATURE SAFEGUARDS
DO NOT APPLY IF RAIN IS EXPECTED WITHIN 24 HOURS
OF APPLICATION. Apply when sir and surface temperature is
between 50-90°F (10-32°C) and will remain between 50° and
90°F for at least 2 hours after application.
APPLICATION
ONE THICK COAT OF DECK START WOOD PRIMER IS
REQUIRED.
Surface should be clean, dry, sound and free of any dirt, oil,
grease, mildew, or any contamination that may interfere with
adhesion. Thoroughly mix the material and stir occasionally
during use. DO NOT THIN.
Using either a ⅜” nap roller, a short nap stain pad or a synthetic
paint brush, saturate and apply generously in a consistent
pattern. Apply a thick coat to the surface to ensure good
penetration. Restore Deck Start Wood Primer appears milky
during application but dries clear. Do not apply the topcoat until
the primed surface is clear and there are no white areas showing.
Allow the coating to dry 1-2 hours before applying the solid
topcoat over the primer.
PRODUCT APPLICATION (cont) .
DRY TIMES
Dries to the touch in 30 minutes and can be recoated in 1 hour
providing the first coat has dried clear. Longer dry time is
required in cooler temperatures and at higher humidity. Full cure
will take approximately 7 days.
COVERAGE
1 gallon covers up to 450 square feet. Once coat is required.
CLEAN-UP
Restore Deck Start Wood Primer is a water-based product
that will clean up with soap and water. For best results,
clean up should be done before the product dries.
Properly dispose of empty container and protect unused
product from freezing.