How to Guide
TECHNICAL DATA INS-01
INSPIRE
PAINT + PRIMER GLOSS SPRAYS
Form: GDH-1302
Rev.: 022817
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Inspire Paint + Primer brings color to life with
long-lasting protection and durability. This product formula
ensures excellent coverage and adhesion on a variety of
interior/exterior surfaces; including wood, metal, plastic,
wicker and more. The Inspire advanced coating system
sprays at any angle, even upside down for those hard-to-
reach areas. The ergonomically-shaped comfort spray tip
has a wider finger pad to reduce finger fatigue caused by
continuous spraying.
TIP: Some plastics made of polyethylene such as Little
Tikes
®*
children’s product are manufactured in such a way
that may hinder maximum paint adhesion. Test paint in a
hidden area first.
.PRODUCTS
SKU (12 ounces) DESCRIPTION
297007 Aluminum
296995 Gloss Apple Red
297012 Gloss Berry Pink
296989 Gloss Black
297051 Gloss Brilliant Blue
297023 Gloss Candy Pink
296996 Gloss Clear
297011 Gloss Colonial Red
297024 Gloss Coral
297059 Gloss Cranberry
297052 Gloss Dark Gray
297010 Gloss Deep Blue
297055 Gloss Grape
297008 Gloss Hunter Green
297064 Gloss Ivory
297016 Gloss Key Lime
297005 Gloss Kona
297048 Gloss Meadow Green
297053 Gloss Navy Blue
297028 Gloss Ocean Mist
297067 Gloss Purple
297009 Gloss Real Orange
297001 Gloss Seaside
297002 Gloss Sun Yellow
296988 Gloss White
297054 Gloss Winter Gray
READ ALL DIRECTIONS BEFORE BEGINNING
PROJECT
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F (10°C)
and 90ºF (32ºC) and humidity is below 65% to ensure
proper drying. Do not apply to surfaces, when heated,
exceed 200°F (93°C). Do not apply to galvanized steel.
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.
* Little Tiles
®
is a registered trademark of The Little Tikes
Company.
PRODUCT APPLICATION .
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent or other suitable cleaning method. Rinse
thoroughly with fresh water and allow to thoroughly dry.
Remove loose paint and rust with a wire brush or
sandpaper. Lightly sand glossy surfaces to create a
surface profile.
WARNING! If you scrape, sand or remove old paint from
any surface, you may release lead paint dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the National Lead Information Hotline at 1-800-
424-LEAD or log on to www.epa.gov/lead.
PRIMING
Use of Inspire Primer provides excellent adhesion and
hiding and is especially recommended for bare wood and
metal.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or more
light coats a few minutes apart to avoid drips and runs. Do
not use near open flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20 minutes, to handle in 1 hour, and is fully dry in
24 hours. Apply a second coat or Clear coat within 1 hour
or after 48 hours. Apply clear in 2-3 light coats a few
minutes apart. NOTE: On plastic, maximum paint
adhesion and durability is achieved in 5-7 days.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not stick pin or other
objects into the stem.