Technical Specifications

TECHNICAL DATA
SRT-06
STOPS RUST
®
HAMMERED BRUSH
1
Form: GDH-707
Rev.: 073119
DESCRIPTION AND USES
Rust-Oleum
®
Stops Rust
®
Hammered Metal Finish provides
long-lasting protection that seals out moisture and protects
the underlying surface against corrosion. The unique
hammered texture covers imperfect surfaces, eliminating the
need to sand to bare metal or prime. The hammered finish is
ideal for weathered and sound rusted metal, while adding a
unique decorative finish. Not for use on galvanized steel.
PRODUCTS
SKU
DESCRIPTION (1 Quart)
239073
Brown
239074
Copper
239075
Dark Bronze
721502
Gold Rush
7211502
Deep Green
7213502
Silver
7214502
Gray
7215502
Black
PRODUCT APPLICATION
SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and
chemical contaminants by washing the surface with a
commercial detergent or other suitable cleaning method.
Rinse thoroughly with fresh water and allow to fully dry.
Remove loos paint and rust with a wire brush. All surfaces
must be dry at time of application.
PREVIOUSLY COATED: Previously coated surfaces must
be sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile. The Stops Rust Hammered Finishes are compatible
with most coatings, but a test patch is suggested.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Apply only when air and surface temperatures are between
50-90°F (15-32°C) and humidity is below 85% to ensure
proper drying. Do not apply to surfaces that will exceed 200°F
(93°C). Do not use on galvanized steel.
Before using, stir thoroughly to ensure any settled pigment is
re-dispersed. If necessary, thin the material with xylene. For
brush or roller, thinning is not normally required. For air
spray, thin up to 15% with xylene. Do not thin with gasoline,
lacquer thinner, turpentine, etc. For airless spray, thinning is
not normally required. Apply with a good quality brush, roller
or spray gun.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures and higher
humidity. Apply 2 coats for full coverage, best appearance
and maximum rust protection. Make sure that corners, edges
and heavily pitted areas are adequately covered. Apply a
second coat after the first coat is dry to the touch (30
minutes). Second coat must be applied within 4 hours or
after 7 days. Dries to handle in 60-90 minutes and is fully dry
in 24 hours.
CLEAN-UP
Clean brush and tools with xylene.