Installation Guide

2. Door Guide Part 1 3. Door Guide Part 2
• Use your level to plumb* your Door.
• With the Door in the closed
position, place the Door Guide half
way into the Door mortise (the
groove that runs along the bottom
of a wood Door).
• Double check that your Door is
plumb.*
• Hold the Door Guide firmly in
position. Using a drill with a Phillips
bit, install a 1” Grabber Screw to
secure your Door Guide to the floor.
_____________________
*Plumb - perfectly vertical.
• Slide the Door into the
open position exposing
the other edge of the
Door Guide.
• Using a drill with a Phillips
bit, install a second 1”
Grabber Screw.
1. Installing Your Door
4. Aligning Anti-jump Bracket
• Lift your Door up to your
Track at a slight angle.
• Carefully rest both Wheel
grooves onto the top of the
track.
• Guide the Door to the
resting position.
• Place your Anti-jump Bracket
against the outside edge of
your Door.
• Slide the Bracket up until
there is a 1/16” to 1/8” space
between the top of the
Anti-jump Bracket and the
bottom of the Track.
5. Installing Anti-jump Bracket
• Holding the Anti-jump
Bracket rmly in place, drill
Grabber Screws into each
of the two holes in the
Bracket until screw heads are
ush with your Bracket.
Installing this Bracket will
ensure your Door will not
come o its Track.
Installing the Door Guide and Anti-Jump Bracket
Page 13