INSTAL L AT ION INST RU CTIONS Box Track System Recommended installation onto a Header that is attached to your wall through wall studs RH ••••••••••••••••••••••••••••••••••••••••• RH043-1.21.
Specifications I N STALL ATI ON I N ST RU CT I ON S Track 3” Length as Ordered 3” Track Hangers 2-9/16” Door Stop 7” 3-1/4” to 5” 1” 3” 1” 5” 1-3/4” ” Brackets End Caps 3” 5-9/16” 1-7/16” 2” RH ••••••••••••••••••••••••••••••••••••••••• 3”
Parts and Tools I N STALL ATI ON I N STRUCTI ON S Tools Needed Tape Measure Pencil Drill with 1/8”, 1/4” and 3/8” bits Short Level Ratchet with 9/16” and 5/8” sockets 9/16” and 5/8” open end and ratcheting wrench Parts Included Track Hangers Grabber Screws Brackets End Caps Self-Tap Screws Washers Lag Screws Door Guide RH •••••••••••••••••••••••••••••••••••••••••
How Measure Your HAN GtoI N G for TR ACK I N S T A L L A T Door I O N ISize N S T RUC T I ON S Doorways Without Trim Door Height 1. Door Opening 2. Door Width Door Opening Adding 2” along either side edge of your door opening to the actual width of your door allows your door to cover the door opening plus 2” of wall on either side. width of door opening plus 2” plus 2” 1. The exact height of your door opening = Door Height 2.
Measuring for Track Position I N STAL L AT I ON I N ST RUCT I ON S We highly recommend you attach your Track to a header, which is attached to your wall through the wall studs. This will provide the stability your wall needs to to hold the weight of your door. Top of Door opening to bottom of Box Track is 3-1/4” 1. Measuring for Track Position 3” • Measure 3-1/4” above your Door Edge. This is where the bottom of your Box Track will be.
Attaching Hangers to Door I N STALL ATI ON I N ST RU CTI ON S 1. Attaching Hangers to Your Door • Lay your Door facing UP on sawhorses. • Measure 1” in from the edge of your Door and pencil a mark on the top of your Door. • Position the Hanger on top of your Door with the single-wheel side facing front (towards you) and the double-wheel side facing back or down. Line the edge of the Hanger base up with the penciled line. • Attach Hanger to your Door using Lag Screws.
End Cap & Door Guide Installation I N STALL AT I ON I N ST RU CTI ON S 1. Hang Door and Attach End Caps Side View - Exposed • Slide both Hanger assemblies into the Box Track, then attach both End Caps using Self-Tap Screws and a flat screwdriver head. Header Drywall Lag Screw Track Bracket Box Track Box Track Door Hanger/Wheel Assembly 3. Door Guide Part 2 2. Door Guide Part 1 • Use your level to plumb* your Door.