Installation Guide

TOP MOUNT REFLEX HANGER Track & Door Installation Instructions
RUSTICAHARDWARE.com
7
3
03
2017
VERSION
Figure 3
Figure 4
Figure 5
Figure 5A
6. Drill out the marked holes using a drill with a
1/4” drill bit (Figure 3).
9. Install remaining spacers with lag screws
and washers (provided) using a 9/16” socket
wrench (Figure 5). Tighten all lag screws.
7. Attach one end of the track to the wall with
one hard or so stop, one lag screw, and one
washer (provided) using a socket wrench with
9/16” socket (Figure 4). Do not tighten.
8. Repeat step 7 for the other end of the track.
10. Stretch rubber bumper (provided)
over hard stop. Repeat for the hard
stop on the other end of the track
(Figure 5A).