Instructions / Assembly

• Lay your Door facing UP on saw horses.
• Pencil a line 2-7/8” parallel from the
Door edge (this marks the proper
location to center the hanger holes over).
• Now mark a horizontal line 1-1/4” from
the top of the door.
• Line up your Hanger holes up over the
vertical line, with the top hole centered
over the 1-1/4” horizontal line.
• Mark the center of both Hanger holes
(these indicate where you should drill to
attach your Hanger to your Door).
• Repeat Step 1 on the opposite Door edge.
1. Measuring and Marking Your Hanger Holes
• Using a drill with a 1/8” drill bit, drill a pilot
hole all the way through the Door
where you have marked.
(one pilot hole for each
hole in the Hanger).
• Repeat Step 2 on the
opposite edge of
the Door.
Door Edge
Door Front
Door Top
• Turn the Door over so it is facing DOWN on the saw horses.
• Using a drill with a 1-1/8” spade bit or Forstner bit
(a Forstner bit is preferred), drill a 7/16”
deep hole, centering your 1-1/8” spade
or Forstner bit directly over the 1/8”
pilot hole.
• Repeat Step 3 on the opposite
edge of the Door.
2. Drilling Pilot Holes
3. Drilling Countersink Holes
4. Drilling Lag Screw Holes
• Turn the Door back over so it is facing UPWARDS
on the saw horses.
• Using a drill with a 3/8” drill bit, drill all the way
through the Door, through your pilot holes.
• Repeat Step 4 on the opposite edge
of the Door.
1/8”
1-1/8”
3/8”
Door Edge
Door Front
Door Top
Door Edge
Door Back
Door Top
Door Front
Door Top
Door Edge
1/8”
Door bottom
with mortise
NOTE: If you are installing a Floor Mount Door Guide, your
door will have a mortise (a groove that runs along the bottom of your
door). Make sure this mortise is facing down towards your oor and
that you install the Door Hangers on the other end.
2-7/8”
4-1/2”
1-1/4”
1-1/4”
2-7/8”
INSTALLATION INSTRUCTIONS