Manualshelf

Installation Guide

ManualsBrandsRustica Hardware ManualsBarn Door Hardware84 in. Garrick Spoked Raw Steel Sliding Barn Door Hardware Kit
12345678910
SPOKED GARRICK HANGER Assembly Instructions
RUSTICAHARDWARE.com
4
3
03
2017
VERSION
Installation
Holes
1. Lay the door face up on a smooth, level surface.
Measure and mark 2-7/8” from the side edge
of the door. Measure and mark 1-1/8” from the
top edge of the door ensuring lines from both
measurements intersect (Figure 1).
Top of Door
Side of Door
1-1/8”
2-7/8”
NOTE:
Doors using Floor Mount Door Guides
will have a groove on the bottom. Ensure
this groove is on the opposite end of the
Door Hanger Installation.
Figure 1
Figure 2
2. Place the hanger on the front of the door
facing up with the upper installation hole over
the intersecting mark. Mark the upper and lower
installation holes on the door with a pencil
(Figure 2).
3. Repeat steps 1 and 2 for the opposite end of the
door. Set the hangers aside.
HANGER INSTALLATION