Installation Guide

FIREPLACE MANTEL Assembly Instructions
RUSTICAHARDWARE.com
5
3
03
2017
VERSION
NOTE:
Do not install anchors in wall studs.
6. Place the cleat on the line made in step
1 (Figure 4).
SUGGESTION:
Use double stick tape on the back of the cleat to help
hold the cleat in place while completing step 7.
7. Mark the wall with an awl through the
pilot holes in the cleat. Set the cleat aside
(Figure 4).
8. Install drywall anchors only where
mantel installation does not intersect
with a wall stud (Figure 5).
9. Drill an 1/8” hole where installation
intersects with a wall stud (Figure 5).
Figure 4
Figure 5