Installation Guide

MAVERICK HANGER Assembly Instructions
RUSTICAHARDWARE.com
4
3
03
2017
VERSION
1. Lay the door with the front facing up on a at,
level surface.
2. Place the hanger on the door (Figure 1).
3. Adjust the placement of the hanger for a 2-3/8”
gap between the top of the door and the bottom
edge of the wheel. Ensure the side of the hanger is
resting 2” from the edge of the door
(Figure 2).
4. Mark the center of each installation hole with a
pencil. (Figure 2).
5. Repeat steps 2-4 for the opposite end of the
door. Set the hangers aside.
2-3/8”
Installation
Holes
2”
NOTE:
Doors using Floor Mount Door Guides
will have a groove on the bottom. Ensure
this groove is on the opposite end of the
Door Hanger Installation.
Figure 1
Figure 2
HANGER INSTALLATION