Installation Guide

RUSTICA LOCK Assembly Instructions
13. Center the hole saw and bit
over the top of the pilot hole
(Figure 6). Drill to a depth of
1/4”.
14. Li the drill and position
the hole saw and bit over the
lower hole. Drill down to a
depth of 1/4” (Figure 7).
15. Li the drill and return
to the upper hole. Repeat the
process of steps 13 and 14 until
the drill bit pierces through the
door (Figures 8,9).
16. Turn the door over and
repeat steps 13 and 14 until the
saw hole has passed completely
through the door (Figures
10,11).
17. Clean the surface around
the hole and re-hang the door
on its track.
Figure 10 Figure 11
3
03
2017
VERSION
RUSTICAHARDWARE.com
7
NOTE:
At 2 1/2” hole saw with pilot bit is neces-
sary for the following procedures.
CAUTION:
Upon completing the drilling process, the
hole saw bit will be VERY HOT. Handle
with care to avoid burns.
Figure 6 Figure 7
Figure 8 Figure 9