Installation Instructions & Warranty Double Handle Bathroom Faucet
® RVF5110ST Double Handle Bathroom Faucet Features • • • • • Stainless steel finish Kerox™ Ceramic Disc Cartridges Solid brass construction Up to 2” deck thickness 3 hole installation(standard 1-3/8” hole) Certified and listed by cUPC to meet Industry Codes and Standards for USA & Canada This product complies with the new federal “lead-free” requirement of the 2014 Reduction of Lead in Drinking Water Act, as well as state legislations in California (AB-1953) and Vermont (S-152).
® RVF5110ST Tools Needed Groove point pliers Safety Tips Adjustable wrench Phillips head screwdriver WARNING • Ruvati reccomends that this product only be installed by a licensed professional. • Always shut off the water supply befor removing the existing faucet and/ or installing a new one. Open the hot and cold knobs on the existing faucet in order to release built up pressure. • Always wear saftely glasses when cutting or soldering water supply lines • Keep the drain covered to avoid losing parts.
® RVF5110ST In the Box Hot Water Handle Cold Water Handle Faucet Body Threaded Shank Threaded Shank Supply Hose Pipe Supply Hose Pipe Hot Water SupplyHose Pipe Cold Water SupplyHose Pipe Metal Washer Locknut Cold & Hot Water Supply Hoses Tee Suply Hoses ® www.ruvati.
® RVF5110ST Installation 1. Remove rubber washer, metal washer, and locknut from the threaded shanks of the faucet body and two handles (Figure 1). If you look closely, you will find a black square rubber gasket sitting in a groove on the underside of the base of the faucet, just above the threaded shank. Do not remove this square rubber gasket. Figure 1 2. Place the faucet body in the middle hole of the deck/sink. Then place the handles into the remaining holes of the deck/sink.
® RVF5110ST 5. Attach the tee to supply hose pipe of the faucet body by inserting the tee onto the end of the supply hose pipe until it will go up no further (Figure 4). Figure 4 6. Now, connect the cold water supply hose to the end of the cold water supply hose pipe by inserting the supply hose onto the end of the hose pipe until it will go up no further. Do the same for the hot water hose (Figure 5). Figure 5 7.
® RVF5110ST 8. Then screw the remaining ends of the hot/cold supply hoses to the corresponding hot and cold water supply using an adjustable wrench or pliers (Figure 9). Figure 7 9. Turn water supply on (Figure 8). Test the faucet by turning it on and off. Make sure there is good water flow and no leaks. Inspect the faucet above and below the countertop to make sure there are no leaks. If there is a leak, turn the water supply off and contact Ruvati Support. Figure 8 ® www.ruvati.
® RVF5110ST Faucet Parts Diagram ® www.ruvati.
® RVF5110ST Trouble-Shooting Guide Issue Cause The water will not completely turn off. There is a dirty, worn out, or damaged washer in the cartridge. Check to see if the ceramic disc is dirty or damaged by removing the handle and the cartridge. Water is leaking from under the handle. The adjusting ring or cap has become loose. Tighten the adjusting ring or cap. The aerator is leaking or has an inconsistant water flow pattern. The aerator does not fit correctly or has become dirty.
® RVF5110ST RUVATI LIMITED LIFETIME WARRANTY At RUVATI, we stand behind our products with a limited lifetime warranty on all faucets. We want every RUVATI customer to be a satisfied customer. REGISTER YOUR PRODUCT. By taking just a few minutes to register, you can improve your experience with Ruvati and enjoy more efficient Warranty Support. Visit www.ruvati.
® RVF5110ST This warranty gives customer specific legal rights, and customer may also have other rights which vary from state to state. When requesting warranty service, you will need to provide: 1. an approved Return Merchandise Authorization number (RMA) issued by Customer Service 2. a dated, valid proof of purchase (payment receipt from an authorized Ruvati reseller) 3.
RVF5110ST REGISTER YOUR PRODUCT. By taking just a few minutes to register, you can improve your experience with Ruvati and enjoy more efficient Warranty Support. Visit www.ruvati.com Tel. (855)478-8284 ® www.ruvati.com Fax (855)239-8053 email: support@ruvati.com www.ruvati.
