Installation Guide

ManualsBrandsRuvati ManualsDrop-in Kitchen SinksDrop-in Stainless Steel 33 in. Top Mount 16-Gauge Single Bowl Kitchen Sink

RVH8001

RUVATI USA

www.ruvati.com

Features

Dimensions

In the Box

Overmount Stainlesss Steel

Kitchen Sink Double Bowl

Printed in USA

Page 1

• Cut out template

• Sink

• Mounting and installing brackets

• One (1) basket strainer (drain)

• Bottom rinse grid

• 16 gauge stainless steel

• Premium 304 grade stainless steel (18/10

Chromium/Nickel)

• Luxurious satin nish - Easy to clean and

long-lasting

• Heavy duty sound guard padding and

undercoating

• Slanted bottom with elegant drain

grooves for easy draining

• Zero radius corners

• Drain placement - Rear

Model

Number Width Length Depth

RVH8001 33” 22” 10”

Summary of content (4 pages)

PAGE 1
RVH8001 ® Overmount Stainlesss Steel Kitchen Sink Double Bowl Features • • • • • • • 16 gauge stainless steel Premium 304 grade stainless steel (18/10 Chromium/Nickel) Luxurious satin finish - Easy to clean and long-lasting Heavy duty sound guard padding and undercoating Slanted bottom with elegant drain grooves for easy draining Zero radius corners Drain placement - Rear In the Box • • • • • Cut out template Sink Mounting and installing brackets One (1) basket strainer (drain) Bottom rinse grid Dime
PAGE 2
RVH8001 ® Attention Installer 1. Read these instructions carefully before installation. Inspect sink for damages. Do not install if the sink is damaged. 2. Ruvati recommends that installation of undermount sinks be done by a professional installer. 3. Sink edges may be sharp and can cause accidental injury to installer if not careful. Wear cut-resistant protective gloves during installation. 4. Templates are only provided as a guide.
PAGE 3
RVH8001 ® 4. Attach mounting clips to the prongs protruding from the underside of the sink rim. Make sure the hooked side of the mounting clip is facing away from the sink (Figure 3). 5. Before installing the sink, place a bead of plumbers putty along the edge of the drain opening inside the sink and press the strainer body into place. Turn the sink upside down and tighten the strainer locknut with a wrench. While tightening, hold the strainer steady with pliers the keep it from turning.
PAGE 4
RVH8001 ® Care and Maintenance • Clean regularly with normal detergent and warm water. • Always make a habit of drying your sink after use and buffing with a soft cloth. This will ensure that no build up of limescale or other mineral deposits can occur. • Clean the sink once a week using a nonabrasive cleanser such as Comet and a clean soft sponge. Scrub in the same direction as the natural grain of the sink. • Never let soap or other household cleaners to dry on the surface of the sink.