Installation Guide

ManualsBrandsRuvati ManualsDrop-in Kitchen SinksWorkstation Drop-in Stainless Steel 15 in. x 20 in. Topmount Bar Prep RV Kitchen Sink 16-Gauge Single Bowl

RUVATI USA

www.ruvati.com

Features

Dimensions

In the Box

• Cut out template

• Sink

• Mounting and installing bracket

• Basket strainers (drains)

• Bottom rinse grids

• Colander Cutting Board

• 16 gauge stainless steel

• Premium 304 grade stainless steel

(18/10 Chromium/Nickel)

• Luxurious satin nish - Easy to clean

and long-lasting

• Heavy duty sound guard padding and

undercoating

• Slanted bottom with elegant drain

grooves for easy draining

• Tight radius corners for easy cleaning

• Drain placement - Rear

RVH8210

Overmount Stainless Steel

Kitchen Sink Single Bowl

Model

Number Width Length Depth

RVH8210 15” (overall) 20” 1 0”

Rev 10/16

Printed in USA

Page 1

Colander Cutting Bboard

Summary of content (4 pages)

PAGE 1
® RVH8210 Overmount Stainless Steel Kitchen Sink Single Bowl Features • • • • • • • 16 gauge stainless steel Premium 304 grade stainless steel (18/10 Chromium/Nickel) Luxurious satin finish - Easy to clean and long-lasting Heavy duty sound guard padding and undercoating Slanted bottom with elegant drain grooves for easy draining Tight radius corners for easy cleaning Drain placement - Rear In the Box • • • • • • Cut out template Sink Mounting and installing bracket Basket strainers (drains) Bottom rins
PAGE 2
® RVH8210 Attention Installer 1. Read these instructions carefully before installation. Inspect sink for damages. Do not install if the sink is damaged. 2. Ruvati recommends that installation of undermount sinks be done by a professional installer. 3. Sink edges may be sharp and can cause accidental injury to installer if not careful. Wear cut-resistant protective gloves during installation. 4. Templates are only provided as a guide.
PAGE 3
® RVH8210 4. Attach mounting clips to the prongs protruding from the underside of the sink rim. Make sure the hooked side of the mounting clip is facing away from the sink (Figure 3). 5. Before installing the sink, place a bead of plumbers putty along the edge of the drain opening inside the sink and press the strainer body into place. Turn the sink upside down and tighten the strainer locknut with a wrench. While tightening, hold the strainer steady with pliers the keep it from turning.
PAGE 4
® RVH8210 Care and Maintenance • Clean regularly with normal detergent and warm water. • Always make a habit of drying your sink after use and buffing with a soft cloth. This will ensure that no build up of limescale or other mineral deposits can occur. • Clean the sink once a week using a nonabrasive cleanser such as Comet and a clean soft sponge. Scrub in the same direction as the natural grain of the sink. • Never let soap or other household cleaners to dry on the surface of the sink.