Installation Instructions

RVM4315
®
RUVATI USA
www.ruvati.com
Installation
1. Placetemplateoncountertop.Position
itsuchthatthesinkwillhaveproper
clearancefromcabinet.
2. Tracealinearoundthetemplate.
Determinewhat“reveal”youwant
yoursinktohave(seepreviouspage)
andbasedonthat,adjusttheline
accordingly.Cutalongtheline.
3. Turnthecountertopupsidedown,
andmarkevenly-spacedpositions
fortheanchorsforthemountingclip.
Werecommend3mountingclipsfor
thesinksides20”andlonger,and2
mountingclipsfortheshortersides.
Drillholesfortheanchors(following
thecountertopmanufacturer’s
instructions)asshownbelow.Use
adrillbitwithstopblocktoavoid
drillingthroughthecountertop.
Secureanchorsintothecountertop
andfastenmountingclipsloosely.
NOTE:Forgranite,marbleorsolidstone
countertopswerecommendusingleadanchors
whicharegluedtothecountertop.
4. Cleantheundersideofthecountertop
andtherimofthesink.Usingagood
qualitysiliconecaulk,applysilicone
caulkevenlyaroundtherimofthe
sink.
5. Placesinkoverthecountertop
opening.Tightenthescrewsuntil
mountingclipsaresnugagainstsink.
6. Checkalignmentofsinktocountertop
openingandmoveslightlyifyouhave
to.
7. Tightendownclipsevenlywithout
overtightening.Removeexcess
silicone.
NOTE:Thefollowinginstructionsareforwoodcountertops.Forgranite,marbleorsolid
stonecountertops,askyourfabricatorforinstallationinstructions.
Rev12/11
PrintedinUSA
Page3