Installation Guide

ManualsBrandsRuvati ManualsOutdoor Bars & Sinks15 in. Single Bowl Workstation Drop-In Marine Grade Stainless Steel Outdoor Sink

RVQ5215

RUVATI USA

www.ruvati.com

Dimensions

In the Box

Topmount Stainless Steel

Marine Grade Workstation Sink

Model

Number Width Length Depth

RVQ5215 15” (overall) 15” 9”

Rev 10/16

Printed in USA

Page 1

Features

• 16 gauge stainless steel

•

Premium T-316 MARINE grade Stainless Steel

- designed for use in boats and yachts

•

Brushed Stainless finish - Easy to clean

and long-lasting

• Heavy duty sound guard padding and

undercoating

• Slanted bottom with elegant drain

grooves for easy draining

•

Zero radius inside corners

• Drain placement - Rear

•

Sink

•

Wood Cutting Board

•

Stainless Steel Colander

• Basket strainer (drain assembly)

• Bottom rinse grid

•

Cutout Template

•

Mounting Brackets

Summary of content (4 pages)

PAGE 1
® RVQ5215 Topmount Stainless Steel Marine Grade Workstation Sink Features • • • • • • • 16 gauge stainless steel Premium T-316 MARINE grade Stainless Steel - designed for use in boats and yachts Brushed Stainless finish - Easy to clean and long-lasting Heavy duty sound guard padding and undercoating Slanted bottom with elegant drain grooves for easy draining Zero radius inside corners Drain placement - Rear In the Box • • • • • • • Sink Wood Cutting Board Stainless Steel Colander Basket strainer (drai
PAGE 2
RVQ5215 ® Attention Installer 1. Read these instructions carefully before installation. Inspect sink for damages. Do not install if the sink is damaged. 2. Ruvati recommends that installation of undermount sinks be done by a professional installer. 3. Sink edges may be sharp and can cause accidental injury to installer if not careful. Wear cut-resistant protective gloves during installation. 4. Templates are only provided as a guide.
PAGE 3
RVQ5215 ® 4. Attach mounting clips to the prongs protruding from the underside of the sink rim. Make sure the hooked side of the mounting clip is facing away from the sink (Figure 3). 5. Before installing the sink, place a bead of plumbers putty along the edge of the drain opening inside the sink and press the strainer body into place. Turn the sink upside down and tighten the strainer locknut with a wrench. While tightening, hold the strainer steady with pliers the keep it from turning.
PAGE 4
RVQ5215 ® Care and Maintenance • Clean regularly with normal detergent and warm water. • Always make a habit of drying your sink after use and buffing with a soft cloth. This will ensure that no build up of limescale or other mineral deposits can occur. • Clean the sink once a week using a nonabrasive cleanser such as Comet and a clean soft sponge. Scrub in the same direction as the natural grain of the sink. • Never let soap or other household cleaners to dry on the surface of the sink.