User's Manual

ruwido austria gmbh ruwido_r107_rf_quick_user_guide_v0.1-DRAFT Page 3 of 6
This document is intellectual property of ruwido austria gmbh and contains confidential information. Reproduction, modification,.
communication to third parties and any other use is strictly prohibited without prior written accordance of ruwido austria. © 2013
Programming your TV
Before you start to program your remote control, make sure your TV is switched on.
Preparation:
To speed up your programming process, the most used TV brands have
short numbers that will be used in the programming process.
Vizio
-
10
Funai/Emerson - 11
Sanyo - 12
Panasonic - 13
Sharp – 14
LG – 15
Toshiba - 16
Sony
-
17
Samsung – 18
Philips – 19
RCA – 20
Insignia - 21
Others - 29
Step 1:
Controlling the TV with the STB remote control is only possible when the
remote control is in the TV mode.
To access TV mode, press the MODE key, until the red TV light flashes.
Step 2:
Press and hold the MODE button for 3 seconds, until the red TV light on
the remote control flashes twice.
Enter the 2-digit code for the brand of your TV (found above) – the red
TV light will flash twice.
Now, press and hold the POWER Button until your TV switches off.
As soon as your TV switches off, remove your finger from the POWER
Button and press OK to confirm – the red TV light will flash twice.
Now press the POWER button again to switch your TV back on.
Finally, press the mode button until the green light is illuminated. Now
you can turn your TV and your digital box on and off simultaneously by
pressing the POWER button.