Installation and Operation Manual
Table Of Contents
- 1 Introduction
- 2 General safety regulations
- 3 Warranty
- 4 Assembly of the fireplace
- 4.1 Removal of covers
- 4.2 Rear screen assembly
- 4.3 Top screen assembly
- 4.4 Installing the fireplace
- 4.5 Placing design bottom plates
- 4.6 Placing lower sidewalls
- 4.7 Log set installation
- 4.8 Placing glass reflector
- 4.9 Placing upper side walls
- 4.10 Placing front window
- 4.11 Connecting fireplace to power
- 4.12 Bluetooth pairing E-one remote
- 5 Installing the fireplace
- 6 E-one operation, design your own experience
- 7 Maintenance
- 8 Technical data
14
6.2 Main on/off switch
Power to the fireplace can be switched off using the on/off
switch (0/I) on the front. The button is located at the top
right, behind the metal flap (see figure). Lift the metal flap a
little towards you.
If the unit is completely disconnected from power, the unit
will be reset to the factory settings.
IMPORTANT: If you do not intend to use the unit for a long
period of time, we advise you to switch off the unit
completely by setting the power button on the unit to the 0
(off) position.
6.3 Hotel switch
The fireplace can be turned off by means of an external
switch. If the two luster terminals are connected together,
the fireplace switches to standby mode.
Please note that the hotel switch may be
inaccessible or difficult to reach after installation.