Installation and Operation Manual
Table Of Contents
- 1 Introduction
- 2 General safety regulations
- 3 Warranty
- 4 Assembly of the fireplace
- 4.1 Removal of covers
- 4.2 Rear screen assembly
- 4.3 Top screen assembly
- 4.4 Installing the fireplace
- 4.5 Placing design bottom plates
- 4.6 Placing lower sidewalls
- 4.7 Log set installation
- 4.8 Placing glass reflector
- 4.9 Placing upper side walls
- 4.10 Placing front window
- 4.11 Connecting fireplace to power
- 4.12 Bluetooth pairing E-one remote
- 5 Installing the fireplace
- 6 E-one operation, design your own experience
- 7 Maintenance
- 8 Technical data
16
8 Technical data
8.1 Specifications
Model: NetZero E-one 100
Input: 120V – 60Hz – 15Amp
Power: 1350 Watt
Heater output: 4,350 Btu/hr
Energy consumption per operating mode
standby mode (W)
1.4
standby mode, incl. anti-reflect function (W)
17
full operating mode, excl. Atmos Heating (W)
75
full operating mode, incl. Atmos Heating (W)
1350
This fireplace must be hardwired to a 120V 15Amp electric
supply. Wiring procedures and connections shall be in
accordance with the national and local codes having
jurisdiction.
8.2 Serial number label
The serial number for the fireplace can be found inside the
fireplace on the left-hand side. To view the serial number
label, remove the front glass from the fireplace. Then
remove the panel that is magnetized to the left side of the
fireplace.
SAMPLE