Manual

4 Channels HDD MDVR (720P) USER GUIDE V6.0 (DRAFT)
- 47 -
1.6.1.1 PTZ CAMERA SETUP
The 1.6.1.1 PTZ CAMERA SETUP screen allows up to four PTZ (Pan, Tilt, Zoom) Cameras to be
programmed, viewed and controlled by the MDVR using its IR Remote Control (IRC) or a compatible PTZ
Joystick Control Console.
Read the manual supplied by the PTZ Cameras manufacturer.
Set the operational codes on the camera as required. Then enter the same codes in the MDVR using the PTZ
Camera screen. Ex.: Pelco D (Protocol), 2400 (Baud), 1 (Data Bit), 1 (Stop Bit), NONE (Check).
The ADDR can be from 1 – 255 and must be unique for each device.
DEVICE
（CH-X）
Select one of four channels for the PTZ Camera to use:
PTZ 1-4
PROTOCOL
Select from two industry standard PTZ operating codes:
PELCO D
PELCO P
BAUDRATE
Select to match the settings on the PTZ Camera
DATA BIT
Select to match the settings on the PTZ Camera
STOP BIT
Select to match the settings on the PTZ Camera
CHECK
Select to match the settings on the PTZ Camera
ADDR
Enter to match the settings on the PTZ Camera. Each PTZ Camera must have a
different address
Action Bar Keys (Select, then press ENTER):
SAVE
To save and activate the new settings
SETUP MENU 1.6
'PERIPHERALS'
SETUP MENU 1.6
'PERIPHERALS'
PERIPHERALS
SETUP 1.6.1
'PTZ SETUP'
PERIPHERALS
SETUP 1.6.1
'PTZ SETUP'
PTZ SETUP
1.6.1.1
PTZ SETUP
1.6.1.1