User Manual

ON
1 2 3 4
The volume can be changed by adjusting the switches (DP-4).
Notes:
(3A)
3A: DIP4=OFF (down), high volume.
DIP4=ON (up), low volume.
After adjusting the DIP sensitivity switch, the settings will only take effect once the system is
disconnected and re-connected. A change in the volume doesn’t require the system to be
disconnected to take affect.
RVS-350P Speed Alarm
When the speed is lower than the alarm, the does not alert the
driver. Speed detection is
calculated by GPS signal. For initial setup, a GPS satellite signal search is required. This
takes about 2 minutes. When GPS signal is found, a voice prompt states 'GPS connection has
been restored'. When there is no GPS signal (vehicle is in underground parking), a voice
prompts states 'No GPS signal'. When no GPS signal is detected (e.g. in underground parking),
the speed alarm will not function. On the back of RVS-350P, DIP switch 2 and 3 are used to
set alarm speed by hand. When the speed alarm is set with computer software this overrides
settings on the physical device. The parameter can now only be changed with the software.