Manual

5
Reverse With Confidence
™
Installation Instructions
Tools Needed
Small flat-tip Screwdriver #2 Phillips Screwdriver Tape Measure
Black Electrical Tape Masking Tape Multimeter
Pliers Pencil/Marker
Testing the system:
After installing the system, test the sensors.
If you see the sensors but not do not hear an audible alert, press the button on the
back of the monitor.
Warning:
Do not stand behind a moving vehicle death or injury could occur. Prior to testing, set the
parking brake on, ignition key on (do not start), step foot on brake and shift the vehicle into
reverse. Ensure that the engine is not running while proceeding with the following tests:
Test the system operation with a large object (piece of wood (60*30*1cm) or other
object (not too small). Start with the object more than 1m away from the vehicle.
Then move the object closer the vehicle and ensure that the buzzer, LED, and distance
indicators display correctly.