Instruction Manual 7" LED Digital Color Rear View Monitor with RCA Connections RVS-6137-RCA Rear View Safety, Inc.
TABLE OF CONTENTS System Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Usage Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Basics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Before You Begin. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Monitor Bracket Installation. . . . . . . . . . . . . . . . . . . . . . 8 - 9 Cable Connection . . . . . . . . . .
SYSTEM DESCRIPTION Congratulations on purchasing this Rear View Backup Monitor! With this manual you will be able to properly install and operate this item. One of our keystone monitors, the RVS-6137-RCA is a high quality 7" LED Digital Panel display and is equipped with autodimming and a built-in speaker. Back-lit buttons illuminate in the dark for easy use, and optional distance grid lines can be adjusted based on camera placement.
If you have questions about this product, contact: SAFETY BASICS Rear View Safety 1797 Atlantic Avenue Brooklyn, NY 11233 Tel: 1.800.764.1028 IN NO EVENT SHALL SELLER OR MANUFACTURER BE LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
IMPORTANT USAGE WARNING ! The Rear View Camera System is designed to help the driver safely detect people and/or objects helping to avoid damage or injury. However, you the driver, must use it properly. Use of this system is not a substitute for safe, proper or legal driving. Never back up while looking at the monitor alone. You should always check behind and around the vehicle when backing up, in the same way as you would if the vehicle did not have the Rear View Camera System.
SAFETY INFORMATION ! Make sure to firmly affix the product before use. ! If smoke or a burning smell is detected, disconnect the system immediately. ! Where the power cable may touch a metal case, cover the cable with a friction tape. A short circuit or disconnected wire may cause a fire. ! While installing be careful with the wire positioning in order to avoid wire damage. ! The Rear View System should only be used when the vehicle is in reverse.
BEFORE DRILLING Please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away from hot or moving parts and electrical noisy components. We recommend doing a benchmark test before installation to insure that all components are working properly. CABLE INSTALLATION Step 2: Fasten all cables and secure all excess cable.
MONITOR DIAGRAM MONITOR BRACKET INSTALLATION Installation of U Bracket Installation of Flushmount Bracket Figure 1.1 Figure 1.2 Figure 1.3 8 Figure 1.
INSTALLING SUNSHIELD Step 1) Put sunshield cover on the display. SUNSHIELD Step 2) Put the monitor with sunshield cover in the back cover (only for embedded monitor) MONITOR SPLITTING BACK COVER SUNSHIELD MONITOR Hold monitor with 2 hands and detach with fingers, as indicated by arrows. (only for embedded monitor) BACK COVER SPLITTING SUNSHIELD SUNSHIELD MONITOR Take the monitor with the left hand and detach with right hand as indicated by the white arrow.
INSTALLING MONITOR Monitor CABLE CONNECTION Camera (Sold Separately) 10 Power GND Back Video 1 Video 2 Audio 1 Audio 2 Rear View Safety Power Yellow to Video 2
MONITOR OPERATIONS CAMERA SELECTION DOWN ARROW MENU/ SELECTION BUTTON UP ARROW ROTATE IMAGE POWER ON/OFF (Exit in Menu Mode) NAVIGATING MENU • "Brightness" "Contrast "Saturation" "Sharpness": adjust image properties • Picture Adjust: Stretch image horizontally (right/left and left/right) • Turn: Toggle between mirror/normal image on each individual channel • Day/Night: Toggle between back-lit buttons and auto dimming • Name: Change name of each individual channel • Trigger source: Toggle channel des
TROUBLESHOOTING PROBLEM SOLUTION • Do a hard reset, unplug all cables leave out for 1 minute and then re-connect them • Check to ensure that the connection to the camera is tight. TROUBLESHOOTING Monitor Displays Blue Screen (and/or) No Signal Display 12 • Verify camera cable is plugged into port labeled Backup Camera • Verify that the blue positive trigger on power harness is put to power 12v+ If problem persists, verify that alternate ports work.
MONITOR SPECIFICATIONS LED Digital Panel Screen Size 7" Dot Resolution 800 X 3 (RGB) X 480 Display Format 16:09 Contrast 500:01 Display Brightness 400 CD/m² Viewing Angle Up: 50° / Down: 60° Left: 70° / Right: 70° Video Input 2 Channels Video Source 1VP-P, 75Ω Power Supply DC 9V - 32V Power Consumption 5W Audio Output 0.5W speaker Operating Temperature -20°C ~ +70° C Storage Temperature -30°C ~ +85°C Video System Auto Auto NTSC/PAL Overall Dimensions 7" (L) X 5.
ONE YEAR WARRANTY REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND.
DISCLAIMER Reverse With Confidence ™ DISCLAIMER REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS.
If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Better Cameras. Better Service. IT’S OUR GUARANTEE.