Instruction Manual

- 34 -
1.4.2.1 SPEED SETUP
The 1.4.2.1 SPEED SETUP screen allows the User to trigger the MDVRs Recording Mode based on low
and high speed thresholds determined by the settings entered. Either or both High and Low settings may be
entered independently.
Vehicle speed can be monitored and recorded using the speed data (KPH or MPH) from either the onboard
GPS (optional) or a more accurate speedometer sensor (optional). The Speed Alert can be set to monitor
Upper and Lower Speed Limits to trigger an alarm, log, and record the event.
SOURCE
Select the source for the speed related data:
GPS Select to use to GPS data to obtain vehicle speed information.
VEHICLE Select to use speed related data from the optional VEHICLE SPEED
MODULE
COEFF(X100)
Only used when the VEHICLE SPEED OPTION is installed:
Set according to User Manual provided with the VEHICLE SPEED MODULE
UNIT
Unit of speed measurement
KMH Kilometers per Hour
MPH Miles per Hour
ENABLE
Select from two options:
ON The selected functions are ‘On’
OFF The selected functions are ‘Off’
NAME
Enter the speed (up to 3 digits) at which to trigger the response required:
LOW(L-SPD) Sends a trigger when the vehicle speed falls below the entered speed
HIGH(H-SPD) Sends a trigger when the vehicle speed exceeds the entered speed
TYPE
Select the Type of Trigger response required:
ALARM Sends a trigger to generate an alarm (See 1.4.5.1 ALARM OUT SETUP)
EVENT Sends a trigger to enter a message in the ALARM/EVENT Log
Action Bar Keys (Select, then press ENTER):
SAVE
To save and activate the new settings
SETUP MENU 1.4
'ALARMS'
ALARM SETUP 1.4.2
'SPEED'
SPEED SETUP
1.4.2.1
MASTER MENU 1.4
'ALARMS'
SPEED SETUP 1.4.2
'SPEED'
SPEED SETUP
1.4.2.1
Mobilemule™