Installation Manual
Reverse With Condence ™
19
• Do a hard reset, unplug all cables
and power cables, leave out for 1
minute, and re-connect them
• Check to ensure that the
connection to the camera is tight
• Verify camera cable is plugged into
port labeled Backup Camera
• Verify that the green positive
trigger on power harness is set to
power 12v+
• Verify camera is on correct camera
input
• Verify cable is connected to
monitor
• Verify camera is connected to
cable
• Connect known working camera
and cable to monitor
• Verify green trigger is receiving
power
No Image On Screen
TROUBLESHOOTING