Installation Manual

REAR VIEW SAFETY
10
Installation Guide
The Power Harness.
• To power the system connect the
power (RED) 12V+ wire to ignition
power and the ground (BLACK)
wire to chassis ground.
• These are the only wires needed to
power the entire system and all
the cameras. Each camera can be
seen at any time by simply
pressing the power button and
using the V1/2 button to toggle.
• The three positive trigger wires
each represent one channel and
will turn on their channel when
the trigger wire is energized with
12V.
• "Camera 3" is the designated
backup channel. To have the the
backup camera come on when you
go into reverse, con-nect the BLUE
wire to reverse power (or any
power source that comes on only
in reverse).
• 2 of the other channels can also be
triggered (side cameras can be
triggered by the turn signals)
• To automatically have camera and
monitor turn ON when vehicle activates,
simply twist BLUE positive trigger 12V+
to Red Power line 12V+ and wire to ig-
nition power.
Note: When the blue wire is
active it will have precedence
over the other triggers.
Therefore, if you wish to use
multiple triggers, do not
attach the blue trigger to
constant power.