Instruction Manual Safety Camera System for Forklifts with 5" Display RVS-577FW Reverse With Confidence ™ 1
TABLE OF CONTENTS Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before Beginning Installation . . . . . . . . . . . . . . . . . . . . . . . In The Box. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Monitor Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Splicing. . . . . . . . . . . . . . . . . . .
NOTE! Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty. Congratulations on purchasing a Safety Camera System! With this manual you will be able to properly install and operate the unit. INTRODUCTION This system is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle.
Please read the entire manual and follow the instructions and warnings carefully. Failure to do so can cause serious damage and/or injury, including loss of life. Be sure to obey all applicable local traffic and motor vehicle regulations as it pertains to this product. Improper installation will void manufacturer’s warranty. USAGE: SAFETY INFORMATION • The system is designed to help the driver safely detect people and/or objects helping to avoid damage or injury.
INSTALLATION: • Electric shock or product malfunction may occur if this product is installed incorrectly. or disconnected wire may cause a fire. • If smoke or a burning smell is detected, disconnect the system immediately. • Do not install the monitor where it may obstruct drivers view or obstruct an air bag device. SAFETY INFORMATION • While installing the Rear View System be careful with the wire positioning in order to avoid wire • Use this product within the voltage range specified. Failure damage.
If you have questions about this product, contact: Rear View Safety 1797 Atlantic Avenue Brooklyn, NY 11233 Tel: 1.800.764.1028 SAFETY INFORMATION IN NO EVENT SHALL SELLER OR MANUFACTURER BE LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away from hot/moving parts and electrical noisy components. We recommend doing a benchmark test before installation to insure that all components are working properly. Step 1: Choose the monitor and camera locations. BEFORE YOU BEGIN Step 2: Install all cables in vehicle, when necessary a 0.
Warning! 1. This monitor is high voltage. Only professionals should open the monitor's case. BEFORE YOU BEGIN 2. Do not watch the video while driving unless you are monitoring the rear view camera display.
In The Box 1 x Color Waterproof Forklift Camera 1 x 5.
Power Harness • To power the system connect the power (RED) 12V+ wire to ignition power and the ground (BLACK) wire to chassis ground. • These are the only wires needed to power the entire system and all the cameras. Each camera can be seen at any time by simply pressing the power button and using the V1/2 button to toggle. • The three positive trigger wires (WHITE-CH1, BROWNCH2, BLUECH3) each represent one channel and will turn on their channel when the trigger wire is energized with 12V.
Wiring WIRING 1. DC 12V-24V 2. Ground 3. Port #3 (Blue) 4. Port #2 (Brown) 5.
Down arrow Camera selection Menu selection Up arrow Rotate image (back/exit when in menu mode) Power on/off MONITOR INTRODUCTION • To turn on the monitor, press “ON”button.
Splicing 1. Red - Power (+) 2. Yellow - Video 3. Green - Mirror / Normal Imaging 4. White - Audio 5.
MONITOR DIMENSIONS Monitor Dimensions • • • • • 14 5" TFT LCD Digital Color Display Built-in speakers for audio Adjustable distance grid lines for backing up reference 3 channel video inputs - Supports 3 cameras Innovative back-lit buttons illuminate in the dark Rear View Safety
Monitor Specifications TFT LCD 5.6" 800 X 3 (RGB) X 480 16:9 / 500:1 400cd/m2 U:50° D:60° L/R:70° 3 channel 1Vp-p, 75Ω DC 12V-24V (+/- 10%) 5W -30°C ~ +80° C Auto NTSC/PAL 5" (L) x 5" (H) x 1" (D) 400G 5G 154.08 (H) X 86.
Camera Specifications CAMERA SPECIFICATIONS Sensor TV System Effective Pixels Sensing Area Scanning System Sync System Resolution Horizontal Sync Frequency Vertical Sync Frequency Video Output Gamma Correction AGC S/N Ratio White Balance Electronic Shutter BLC Operation Frequency Line of Sight Range Receiving Sensitivity Video Codec Frame Rate Transmission Power Spread Spectrum Delay RF Bit Rate Operating Temperature Storage Temperature Power Supply Waterproof Rating Viewing Angle 16 1/4" CMOS ASX340CS
Troubleshooting Monitor Displays Blue Screen & Displays No Signal • Do a hard reset, unplug all cables and power cables leave out for 1 minute and then reconnect them • Check to ensure that the connection to the camera is tight • Verify camera cable is plugged into port labeled Backup Camera trigger on power harness is put to power 12v+ If the problem still persists, verify that alternate ports work. If alternate ports do not work, remove Blue Trigger wire from 12V+ and select alternate channels.
WARRANTY ONE YEAR WARRANTY REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES OF ANY KIND.
DISCLAIMER Reverse With Confidence ™ DISCLAIMER REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS.
If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Better Cameras. Better Service. IT’S OUR GUARANTEE.
