Installation Manual

REAR VIEW SAFETY
10
Wiring Camera & Monitor
The Power Harness.
• To power the system connect
the power (RED) 12V+ wire to
ignition power and the ground
(BLACK) wire to chassis ground.
• These are the only wires
needed to power the entire
system and all the cameras.
Each camera can be seen at
any time by simply pressing
the power button and using
the V1/2 button to toggle.
• The three positive trigger wires
(WHITE-CH1, BROWNCH2,
BLUE-CH3) each represent one
channel and will turn on their
channel when the trigger wire
is energized with 12V.
• "Camera 3" is the designated
backup channel. To have the
the backup camera come on
when you go into reverse, con-
nect the BLUE wire to reverse
power (or any power source
that comes on only in reverse).
• The other channels can simi-
larly be triggered (i.e. side cam-
eras can be triggered by the turn
signals etc.)
• To automatically have camera
and monitor turn ON when vehi-
cle activates, simply twist BLUE
positive trigger 12V+ to Red
Power line 12V+ and wire to ig-
nition power.
Note: This setup will disable
the menu in channel 3. To
access the menu simply move
to channel 1 or 2 and all the
changes will apply to channel
3.
Note: When the blue wire is
active it will have precedence
over the other triggers.
Therefore, if you wish to use
multiple triggers, do not
attach the blue trigger to
constant power.