Installation Manual

Rear View Safety
12
TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM SOLUTION
Monitor Displays
Blue Screen
(and/or) No
Signal Display
 Do a hard reset, unplug all cables leave out for
 minute and then re-connect them
 Check to ensure that the connection to the
camera is tight.
Verify camera cable is plugged into port labeled
Backup Camera
Verify that the blue positive trigger on power
harness is put to power v+
If problem persists, verify that alternate ports
work. If alternate ports do not work, remove
Blue Trigger wire from 12V+ and select alternate
channel.
Monitor Will
Not Power-Up
(no backlight on
power button)
• Check fuse
• Check v+ to monitor
 Check ground connection
No Image
on Screen
Verify camera is on correct camera input
Verify cable is connected to monitor
Verify camera is connected to cable
• Connect known working camera & cable to
monitor
Verify Blue trigger is receiving power
No Audio
from Camera
Verify chosen camera has audio
• Verify volume setting