Operation Manual
Schütze™ .177/NA 580/NA fps 400 yds
Model 34 .177/.22 1000/800 fps 575 yds
34 Meisterschütze™ Pro .177/NA 1000/NA fps 575 yds
34 Meisterschütze™ PC .177/NA 1000/NA fps 575 yds
Model 34 Panther .177/.22 1000/800 fps 575 yds
Model 34 Panther Pro .177/NA 1000/NA fps 575 yds
Model 34 Panther PC .177/NA 1000/NA fps 575 yds
Model 350 Magnum .177/.22 1250/1050 fps 625 yds
Model 350 Feuerkraft™ .177/.22 1250/1050 fps 625 yds
Model 350 Feuerkraft™ PC .177/.22 1250/1050 fps 625 yds
Model 48 .177/.22 1100/900 fps 600 yds
Model 52 .177/.22 1100/900 fps 600 yds
Model 52 Luxus .177/.22 1100/900 fps 600 yds
Model 54 .177/.22 1100/900 fps 600 yds
Model 46 Stutzen .177/NA 900/NA fps 550 yds
Model 460 Magnum .177/.22 1200/1000 fps 650 yds
WARNING:
Operation
Manual
for
Break-Barrel, Side-Lever,
& Under-Lever Pellet Rifles
the rie shoots to the right: adjust clockwise. If to
the left: adjust counterclockwise.
– RWS Models 48, 52 and 54 are equipped with
an adjustable front sight [(3)-See Fig. 7b]. It can
be adjusted by loosening the screw (4), move it
by sliding to a lower or higher position. Afterwards
retighten the screw.
NEVER STORE A LOADED OR COCKED GUN. Put “ON SAFE” and
unload pellet from the gun. Keep rie away from children and untrained
shooters. Store pellets separately from the rie to keep them from
untrained shooters. Protect your rie from moisture and dirt; clean gun
and wrap it in a smooth, dry cloth, or store the gun in the package it came
in when new. If you are going to store your airgun for an extended length
of time be sure the barrel is protected. This can be accomplished by
coating the bore with a good acid-free and resin-free oil or grease. Always
use a soft brush and insert the cleaning rod from the breech end on break
barrel ries. On side cocking and under lever ries, insert the cleaning rod
from the muzzle end. Remove the oil/grease completely before the next
use. Always check to see if the airgun is “ON SAFE” and unloaded when
getting it from another person or from storage.
Your RWS air rie is designed to re caliber .177 or .22 lead pellets only.
We recommend the use of RWS Pellets because of their superb accuracy
and dimensional uniformity. The correct caliber is clearly stamped on the
barrel near the breech block or on the breech block.
If the air rie is red without a lead pellet or cleaning pellet in the
breech, it will cause the piston to bottom out in the cylinder which can
permanently damage the air rie.
The working parts, like
piston and mainspring require very little
lubrication. Two (2) drops of RWS Chamber
Lube every 1000 shots will sufce. It is easily
applied through the compression chamber port
with a 3 1/2" applicator needle (See Figures 8a &
8b). The wearing surfaces at the barrel hinge, the
cocking arm and the trigger mechanism should
be lubricated every 1000 shots with RWS Spring
6007 South 29th Street, Fort Smith, Arkansas 72908 USA
Phone: 1-479-646-4210 www.UmarexUSA.com
BREAK
BARREL
Fig. 8a
Fig. 8b
SIDE LEVER &
UNDER LEVER
Fig. 9
Fig. 10a
BREAK
BARREL
Fig. 10b
SIDE COCKING
& UNDER LEVER
12R07
Shoots Lead Pellets
WARNING:
WARNING:
Fig. 7b
(4)
(3)
The RWS warranty covers RWS airguns (original owner) against any
defect in workmanship and materials for the life of the airgun. Any
RWS airgun covered by this warranty which is found to have a defect
in workmanship or materials will be replaced or repaired, at the option
of RWS, for only the cost of shipping and handling.
Parts that can wear out, such as seals and mainsprings, will be
warranted for the registered airgun for 18 months from the original
retail purchase date.
Repairs can only be made by our Authorized Service Center. This
limited lifetime warranty becomes invalid for any gun which is handled
improperly, modied, or disassembled. Should any defect appear, call
Umarex USA, Phone (479) 646-4210 for repair or replacement, at the
option of the warrantor and to obtain an RA (Return Authorization)
Number. Once you have received an RA Number from the RWS
service department, package the gun carefully in a solid shipping box,
include a money order or check in the amount of $30.00 to cover the
cost of shipping and handling. Write the RA Number boldly on the box
and return, prepaid to:
Umarex USA, 6007 South 29th Street Fort Smith, Arkansas 72908.
The name, address and phone number of the shipper must be
included in the package, along with a note explaining the defect found.
Under the warranty, you have our assurance of a lifetime of shooting
pleasure with a RWS airgun.
This warranty does not cover guns used for commercial
purposes or by institutions. These guns are covered only by our
regular ve year policy.
Never leave any airgun cocked for more than a few minutes because
the mainspring can weaken. Only recommended lead pellets should
be used. Other projectiles, such as steel darts, will damage the riing
of the barrel.
RWS
®
LIMITED LIFETIME WARRANTY
ONLY FOR GUNS SOLD IN THE USA
Cylinder Oil. (See Fig. 9) Mainsprings should be oiled every 1000 shots
with six (6) drops of RWS Spring Cylinder Oil (See Figures 10a and 10b).
Remember, a little is good – a lot is not better.
In day to day use, very little dirt or residue will accumulate in
the bore. This can be removed by using soft felt RWS Cleaning Pellets.
Note: High quality RWS lead pellets not only increase accuracy, they do
not leave a lead deposit. During periods of regular use the bore of the
barrel should be cleaned periodically by means of a felt wad or cleaning
rod with wool mop. Wire brushes should not be used. Insert rod from
breech end, do not remove barrel seal.
The exposed metal parts (rear sight, receiver, screw heads,
sight hood, etc.) are a gun blue nish and MUST be wiped clean using a
slightly oiled cloth after handling to prevent rust. Use light acid free and
resin free oil. RWS Spring Cylinder Oil is excellent for this.
WARNING: