Specifications

Avolites Rolacue Operators Manual - page 53
rq96man 19/09/1996 18:30
• You may then wish to Renumber following the procedure in Section
7.14.6 above.
⇒ You cannot use the blue DELETE button on the Program Select bank for
this function.
7.14.8 PREVIOUS 15 (20) STEPS
As the Pearl only has 15 Playback Faders (and the Sapphire 20) you cannot
fit more than 15 (20) Chase Steps onto the Playback Faders at a time.
Pressing this button puts the previous 15 steps of a long Chase onto the
Playback Faders for editing. If you are already at the start of a Chase, this
function will do nothing.
7.14.9 NEXT 15 (20) STEPS
And surprise surprise, this puts the next 15 (20) Chase Steps onto the
Playback Faders so that you can edit any of the Steps in a very long Chase.
If you are already at the end of a Chase, this function will do nothing.
7.14.10 Exiting UNFOLD
To exit UNFOLD :
• Press the UNFOLD button again.
Its LED will go out, and you will be restored to
the Playback page you started with.
7.15 RESTORE CHASE OUTPUT
This function is used during Chase programming and allows the Chase being
programmed to be run, either to see how it looks or to check on the contents
of a step, possibly because you have forgotten which Fixtures were used in a
previously recorded step.
To use this function you must be in the middle of programming a Chase, with
the CHASE LED flashing.
• Press RESTORE CHASE OUTPUT.
Its LED is lit. All other LED’s unchanged.
• Press CLEAR twice.
To clear the Programmer.
• Lower any Preset Faders.
They will only confuse the output.
• Put the Chase Playback Fader up.
The Chase will run as far as you have programmed it. You can stop,
reverse and step the Chase as required but not EDIT it.
• Press RESTORE CHASE OUTPUT to resume programming.
Its LED goes
out. All other LED’s unchanged.
7.16 How Playback Faders run timed Chases
The Playback Fader will govern the maximum level to which an HTP Channel
will output, but it will not affect any of the times.
The LTP Channels run as normal.
7.17 Copying a Chase
The word COPY means two things when COPYING a Chase (or Memory).