Specifications

Avolites Rolacue Operators Manual - page 62
rq96man 19/09/1996 18:30
8.4.2 Using the Focus Mask when recalling a Preset Focus
You can use Preset Focuses in Program mode or Take Over Run mode.
See Section 12.1 Run Modes.
The Focus Mask settings also determine which Attributes are recalled when
you use a Preset Focus in any given Preset Bank.
You can if necessary change the Focus Mask to recall different Attributes
from the Preset Focus, provided that these Attributes have been stored. You
can actually recall any Attribute stored in the Preset Focus from any Preset
Bank, provided that the Focus Mask is set appropriately.
⇒ If you change the Focus Mask when you recall a Preset Focus, unless
you restore it to its original settings, these are the Attributes which will
store when you store a new Preset Focus or edit an old one. This can
make the results of using Preset focuses seem unpredictable as you can
end up with a Focus Mask which is trying to recall Attributes that were
never stored to begin with.
8.4.3 Default settings of the Focus Mask
After a WIPEALL the Attributes in the Focus Mask are defined as follows :
Bank Selection Usage
1 All Dimmer
2 2 Shutter
Iris
3 3 Pan
Tilt
4 4, 9 and
10
Colour Wheel
Colour Wheel
5 5 Focus
Zoom
6 6 Gobo 1
Gobo 2
7 7 Gobo modify 1
Gobo modify 2
8 8 Speed
Speed pan/tilt
9 4, 9 and
10
Yellow
Effect
10 4, 9 and
10
Magenta
Cyan
11 11 Control
12 12 Reduction
Note that :
In Preset Bank 1 ALL Attributes are set.
In Preset Banks 4, 9 and 10, which are usually used to control Colour Wheel
and Colour Mix functions, all Colour Attributes are set.