Specifications

Avolites Rolacue Operators Manual - page 63
rq96man 19/09/1996 18:30
8.4.4 Setting the Focus Mask
• Turn the Key to Program or Run in Take Over Run mode. See Section
12.1 Run Modes
.
• Either press and hold down a grey Preset Focus button or press the
STORE FOCUS button.
• Press the Preset Bank buttons to select or deselect Attributes on the
Focus Mask.
Lit LED’s in the Preset Bank buttons indicate selected banks. Turn
banks on and off by pressing the Preset Bank Buttons.
• Release the Preset Focus button or press the STORE FOCUS button
again.
8.5 Programming a Preset Focus
• Check that the Focus Mask is correctly set.
Lit LED’s in the Preset Bank
buttons indicate selected banks. Turn banks on and off by pressing the Preset Bank
Buttons
.
The Preset Focus will include all the Fixtures which have Attributes in the
Programmer of the same type as the settings on the Focus Mask.
This is a Record by Channel type function, so only Attributes that have
actually been touched will be in the Programmer.
eg. If you press CLEAR, then change the colours of your Intellabeams and
the Pan and Tilt of your Trackspots, if then you record a Positional Preset
Focus, it will only contain the Trackspots.
8.6 Using a Preset Focus
Two methods are now available for selecting Fixtures and applying Preset
Focuses. These are the ‘diagonal copy’ and the ‘select and apply’ method.
8.6.1 The SELECT AND APPLY method
• Turn the Key to Program or Run in Take Over Run mode. See Section
12.1 Run Modes
.
• Select the Preset Bank of the Attribute you wish to use.
• Select your Fixtures by pressing blue Preset SWOP buttons.
Fixture LED’s
will light provided that the desk is in Fixtures mode. You can select any number of
Fixtures.
• Whilst still holding the Preset Focus button check the Focus Mask is
correctly set.
Lit LED’s in the Preset Bank buttons indicate selected banks. Turn banks
on and off by pressing the Preset Bank Buttons
.
• Select the relevant Preset Bank.
• Turn the Key to Program.
Puts you in LIVE PROGRAM MODE.
• Create the Preset Focus look on stage.
• Press the blue STORE FOCUS button on the Program Select Bank.
• Press the grey Preset ADD button that you wish to store the Preset
Focus onto.
• Apply a Preset Focus by pressing a Preset Focus button.