Specifications

Avolites Rolacue Operators Manual - page 74
rq96man 19/09/1996 18:30
Problem : The Colour Mix area has little or no effect on the colour output
from a Fixture
Solution : Check that the Graphics Tablet is working correctly by clicking on
CLEAR then re-selecting the Fixtures with the Tablet. Watch the Preset
SWOP LED’s on the desk to ensure that it is mirroring the Tablet (assuming
you are set to Fixtures not Mimics). If this is working properly, set the
Luminosity bar to 50% and try again. Make sure your Fixtures have a Colour
Mix facility, not just Colour Wheels.
11. The USER SETTINGS MENU
The USER SETTINGS Menu allows you configure certain features of the
desk.
• Turn the Key to Program.
Puts you in Live Program Mode menu.
Use the Up and Down Cursor Keys to move up and down the Menu.
Use the Left and Right Cursor Keys to toggle menu options.
11.1 Setting 1. CHASE PARAMETERS
Does nothing. This function is transferred to Softbutton A in the Live
Program Mode menu.
11.2 Setting 2. MEMORY FADER OFF AT XX
This setting sets the level at which the Playback Fader stops a sequence
running.
This value must be lower than the MEMORY FADER ON value. (See below.)
11.3 Setting 3. MEMORY FADER ON AT XX
This setting sets the level of the Trigger Point at which LTP functions are
activated on the Playback Channels. it also sets the level at which Chases
start to run.
This value must be lower than the MEMORY FADER OFF value. (See
above.)
11.4 Setting 4. Run Modes
The available Run Modes are :
11.4.1 NORMAL RUN MODE
11.4.2 TAKEOVER RUN MODE
11.4.3 TWO PRESET MODE
All these Modes are fully discussed in Chapter 12 Running your show.
11.5 Setting 5. Record Modes
The available Record Modes are :
• Press Softbutton B [USER SETTINGS].
Puts you in the User Settings Menu.