Specifications

Avolites Rolacue Operators Manual - page 75
rq96man 19/09/1996 18:30
11.5.1 Record by INSTRUMENT
11.5.2 Record by CHANNEL
11.5.3 Record ALL CHANNELS
All these Modes are fully discussed in Chapter 6.1 Recording Modes.
11.6 Setting 6. AUTOCOPY
When Autocopy is enabled, Slaved Fixtures automatically receive all three
colour Mix Channels when only one of them has been Slaved.
Unfortunately it does not put all the Colour Mix Channels into the
Programmer when only one of them has been edited and you are in Record
by Channel mode. Perhaps one day it will!
11.7 Setting 7. CHASE PARAMETERS
This was used to control a chase parameter in previous software revisions.
This function can now be programmed for each individual chase and can be
found on Softbutton A in the Live Program Mode menu.
11.8 Setting 8. DISABLE TIMECODE
This function enables and disables incoming Timecode into the desk.
11.9 Setting 9. AUTOCONNECT
Enabling the Chase Autoconnect means that the most recently replayed
Chase will automatically be Connected to the Wheel(s).
As you change pages on the Roller, the most recently Connected Chase on
each page will Autoconnect.
Use this Mode for fast access to Chases as they are replayed.
11.10 Setting 10. Remote Connected / G - Tablet
This mode configures the Serial Port on the back of the desk for different
input devices. Select the appropriate mode for running a Stage Remote or
Graphics Tablet. See Chapter 14 The Graphics Tablet and Chapter 15 The
Stage Remote.
⇒ If a connected device does not appear to be working correctly, toggling
the settings on this User Setting until the correct setting is reselected may
help.
11.11 Setting 11. GO ON ADD disable
SAPPHIRE ONLY.
Disabling this setting prevents the ADD button on a Playback Channel to be
used as a GO button for stopping and starting a Chase.
11.12 Setting 12. OLD or NEW Screen type
SAPPHIRE ONLY.