Specifications

Avolites Rolacue Operators Manual - page 77
rq96man 19/09/1996 18:30
11.18.2 Softbutton B - VALID RANGE
See Chapter 16 The Script File System.
Pressing this Softbutton allows you to set a range a values for valid
incoming Timecode. Timecode is not within the values will be rejected and
the system will use the Internal Timer to maintain a seamless flow of
Timecode until the incoming Timecode falls back within the valid range.
To enter the range of values :
• Enter the lowest value on the Keypad.
• Press Softbutton A [MINIMUM TC].
• Enter the highest value on the Keypad.
• Press Softbutton B [MAXIMUM TC].
• Press EXIT to quit.
11.19 Helps and Hints
Problem : The LED mimic doesn’t show the level of the Channel.
Solution : Toggle the FIXTURES OR MIMICS setting.
12. Running your show
12.1 Run Modes
Turning the Key to Run puts the desk into Run Mode. This disables all the
programming features of the desk, and allows only Playback functions to
operate.
The Key can be removed to lock the desk in this Mode.
There are three different Run Modes that you can use for running a show.
These are :
Normal Mode
Takeover Mode
Two Preset Mode.
In all of these Modes, operation is basically the same. Raising a Playback
Fader will activate the Memory or Chase recorded on it and the LED will light
up proportionally to the level. If you change Roller Facets with a Playback
Fader up, the LED will flash.
You can VIEW any Screen from all Run modes. See Section 9.1 More about
the Screen - using VIEW.
12.1.1 Normal Run mode
⇒ This Mode has the fastest response from the ADD and SWOP buttons.
In Normal Run or Wide mode when you switch the Key from Program to
Run, the Programmer is cleared and you no longer have access to any
LTP Channels.
This mode still has access to HTP Channels however.