Specifications

Avolites Rolacue Operators Manual - page 80
rq96man 19/09/1996 18:30
button in Run
modes
Takeover Run
As in
Program
mode,
allowing
selection of
Preset
Focuses etc.
As in
Program
mode
allowing
selection of
instruments.
As normal
run, but the
response
time of these
buttons will
be slower.
Disabled
Two Preset As normal
run
As normal
run
As normal
run
As normal
run
12.3.1 Changing Run Modes
You can change Run Modes two different ways.
Either :
• Turn the Key to Program.
• Press [USER SETTINGS].
• Use the Up and Down Cursor Keys to go down to Setting 4 and the Left
and Right Cursor Keys to cycle the Run Modes.
• Turn the Key to Run.
Or
• Turn the Key to Run.
• Press Softbutton A to toggle Run Modes.
The Mode may not toggle through all
three modes depending on what is selected in the USER SETTINGS
.
The mode in use is shown on the Screen prompt line.
12.4 Help and Hints
Problem : You cannot control LTP Channels in Run mode.
Solution : Change to Takeover Run mode.
Problem : My ADD and SWOP buttons seem very slow.
Solution : Use Normal Run Mode.
Problem : My ADD and SWOP buttons don’t control my Intelligent Fixtures.
Solution : Use Takeover Run Mode.
13. Disk functions and software
13.1 The Show Disk system
The DISK System allows you to Save and Load a show, Format a disk, and
Verify that a saved disk matches the show loaded in the desk.
You should use 720K disks Double sided, Double density formatted for a PC.
We suggest 3M 12882, these are preformatted and so save you the trouble
of formatting before use. Disks other than 720K may cause problems.