ORIGINAL INSTRUCTIONS Electric Silent Shredder RSH2845T
Important! It is essential that you read the instructions in this manual before assembling, operating and maintaining the product. Subject to technical modification.
GENERAL SAFETY RULES WARNING The product is not intended for use by children or persons with reduced physical, mental or sensory capabilities. Young children should be supervised at all times by someone other than the operator to ensure that they do not play near or with the product. WARNING When using the product, basic safety precautions should be followed to reduce WKH ULVN RI ¿UH HOHFWULF VKRFN DQG SHUVRQDO injury. Read all of these safety instructions carefully before operating the product.
SPECIFIC SHREDDER SAFETY RULES OPERATION Ŷ Before starting the product, look into the feeding chamber to make certain that it is empty. Ŷ Keep your face and body away from the feed intake opening. Ŷ Do not allow hands or any other part of the body or clothing inside the feeding chamber, discharge chute, or near any moving part. Ŷ Always be sure of your footing. Keep firm footing and balance. Do not overreach. Never stand at a higher level than the base of the product when feeding material into it.
Ŷ Be aware that the cutting means can still be moved even when the power is off or if the interlock switch is engaged. Ŷ To ensure the best performance from the product, it must be kept clean. Ŷ Always clean the product immediately after use. Wherever possible use a stiff brush inside the feed and discharge chutes and a dry cloth on the outside of the product. Ŷ Do not allow material to become dry and hard on any of the product surfaces, but particularly on the blades.
MATERIAL SHREDDING METHOD Twigs and up to 6 mm diameter. Feed into the feeding hopper at a rate which the product will accept without overloading. Branches and up to 45 mm in diameter. Clip off all side growth with secateurs before feeding into the feeding hopper. Bedding plants, Knock soil and stones weeds and off the roots to avoid shrubby growth. damage to the blades. Freshly cut foliage, hedge, and kitchen waste.(I.e. cabbage leaves, vegetable peelings etc.
Wear non-slip, heavy duty gloves. WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. Conforms to all regulatory standards in the country in the EU where the product is purchased. CAUTION Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. EurAsian Conformity Mark Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
x1 x2 x2 x1 x2 x2 x2 x2 x2 x2 x6 x1 x1 14 mm 6 x1
2 3 4 1 5 9 6 7 8 7
1 2 7 8 8
3 4 5 6 1 3 2 1 2 2 1 4 3 4 9 10 11 2 1 1 2 9
10
p.13 p.15 p.16 p.18 p.
12 p.22 p.23 p.24 p.
1 2 2 1 13
3 14
1 2 1 2 1 2 3 2 1 15
1 2 3 4 16
5 2 1 17
1 2 1 5 mins 2 3 4 18
5 2 1 19
1 1 2 2 1 3 4 20 2
5 6 2 1 21
1 1 2 3 22 2
1 1 2 2 2 1 3 23
1 1 2 3 24 2
1 2 1 2 3 1 2 20141230v1 4 25
TROUBLESHOOTING PROBLEM Motor does not run. Material to be shredded is not drawn in CAUSE ACTION The overload protection has operated Wait for the motor to cool, press the reset button. Switch on the product again. Power failure Check the power supply cable, the plug and the house fuse. The material is jammed in the feeding funnel. Follow instruction in the manual for clearing obstructions. Shaving plate is too far from the cutting means.
PRODUCT SPECIFICATIONS Rated power 2800W(S6, 40%), 2300W(S1) Rated voltage 230-240V ~50Hz Maximum cutting diameter 45 mm Idle speed 40 min-1 Weight 28.8 kg Noise emission level (in accordance with EN 50434:2014 Annex FF) A-weighted sound pressure level at operator’s position Uncertainty of measurement A-weighted sound power level Uncertainty of measurement 80.7 dB(A) 2.5 dB 99.30 dB(A) 2.26 dB NOTE: 1. The S6(40%) indicates a load profile of 4 minutes load and 6 minutes idle time.
GUARANTEE In addition to any statutory rights resulting from the purchase, this product is covered by a guarantee as stated below. 1. The guarantee period is 24 months for consumers and commences on the date when the product was purchased. This date has to be documented by an invoice or other proof of purchase. The product is designed and dedicated to consumer and private use only. So there is no guarantee provided in case of professional or commercial use. 2. There is, in some cases (i.e.
AUTHORISED SERVICE CENTRES ACD PLANT LTD 145 Southbank Road Coundon Coventry, West Midlands CV6 1FG Phone: 02476 594348 Email: danmcgunigle@acdplant.co.uk Web: www.acdplant.co.uk C J Sinclair Limited 44 Victoria Road St Peters Broadstairs, Kent CT10 2UG Phone: 01843 869400 Email: repairs@cjsinclairltd.co.uk Web: www.cjsinclairltd.co.uk CBS Power Tools Limited Unit 4, V P Square Storeys Bar Rd, Fengate Peterborough, Cambridgeshire PE1 5YS Phone: 01733 343031 Email: steve@cbspowertools.co.uk Web: www.
DECLARATION OF CONFORMITY Techtronic Industries GmbH Max-Eyth-Straße 10, 71364 Winnenden, Germany Herewith we declare that the product Electric Silent Shredder Brand: Ryobi Model number: RSH2845T Serial number range: 44436801000001 - 44436801999999 is in conformity with the following European Directives and harmonised standards 2006/42/EC, 2004/108/EC, 2000/14/EC, 2005/88/EC, 2011/65/EU, EN 55014-1:2006+A1:2009+A2:2011, EN 55014-2:1997+A1:2001+A2:2008, EN 61000-3-2:2006+A1:2009+A2:2009, EN 61000-3-11:2000,