Router And Jig Saw Mounting Kit Operator's Manual

Page 7
ROUTER MOUNTING (Cont'd)
TO ASSEMBLE TABLE CLAMPING BRACKET
(Cont'd)
1. Remove end cap from rear rail as shown in figure 8.
2. Slide one of the special 5/16 in. T-nuts into channel of
rear rail.
3. Orient table clamping bracket as shown and secure
with a 5/16 in. washer and 5/16-18 x 3/4 in. knob bolt.
Note: Table clamping bracket fits in bottom slot of rear
rail. The slotted top of this bracket wraps around the
raised portion on the underside of the accessory table,
clamping it tightly against the rear rail.
4. Tighten knob bolt securely.
5. Reassemble end cap to rear rail.
FINAL ASSEMBLY
See Figure 9.
After all router mounting parts have been assembled, your
set-up should be similar to the illustration shown in figure 9.
1. Compare your set-up to the set-up shown in figure 9 and
make any necessary adjustments.
2. Recheck all knob bolts, loose parts, etc. and securely
tighten if necessary.
PREPARING FOR OPERATION
See Figure 9.
1. Adjust dust cover so that it will not come in contact with
workpiece during cutting operation.
2. Direction of feed of workpiece is from right to left as
shown by the arrow in figure 9.
3. Direction of feed must always be so that the workpiece
is being thrust against the sharp edges of rotating bit.
4. Workpiece must always be tight against guide fence.
Infeed fence should be adjusted to support uncut
workpiece while the outfeed fence should be adjusted
properly to support the workpiece after the cut passes
the router bit.
Fig. 9
Fig. 8
TABLE CLAMPING BRACKET
SHOWN COMPLETELY ASSEMBLED
ACCESSORY TABLE
TABLE
CLAMPING BRACKET
T-NUT
REAR RAIL
5/16 in. WASHER
KNOB BOLT
END CAP
ROUTER KIT SHOWN COMPLETELY ASSEMBLED
DIRECTION OF FEED IS FROM RIGHT TO LEFT
AGAINST SHARP EDGES OF ROTATING BIT