Manual

17
OPERATION
Fig. 17
BLADE GUIDE NOTCH
BEVEL SCALE
WING
NUT
MOTOR
HOUSING
Fig. 18
BEVEL CUTTING
See Figures 17 - 18.
To make the best possible cut, follow these helpful hints.
Align the line of cut with the inner blade guide notch on
the base when making 45° bevel cuts.
Make a trial cut in scrap material along a guideline to
determine how much you should offset the guideline on
the cutting material.
Adjust the angle of the cut to any desired setting between
zero and 51.5°. Refer to TO ADJUST BEVEL SETTING
next.
TO ADJUST BEVEL SETTING
See Figure 17.
Unplug the circular saw.
Loosen wing nut.
Raise motor housing end of saw until you reach desired
angle setting on bevel scale.
Tighten wing nut securely.
WARNING:
Attempting a bevel cut without having the wing nut se-
curely tightened can result in serious injury.
TO BEVEL CUT
See Figure 18.
Hold the saw firmly with both hands as shown.
Rest the front edge of the base on the workpiece.
Start the saw and let the blade reach full speed.
Guide the saw into the workpiece and make the cut.
Release the switch trigger and allow the blade to come
to a complete stop.
Lift the saw from the workpiece.