LASER CIRCULAR SAW OPERATOR'S MANUAL CSB140LZ

10
FEATURES
KNOW YOUR LASER CIRCULAR SAW
See Figure 1.
Before attempting to use this product, familiarize yourself
with all operating Features and Safety Rules
EDGE GUIDE
Edge guide is used when making long or wide rip cuts with
the saw.
SWITCH
The circular saw is equipped with a pre-travel safety switch
which reduces the possibility of accidental starting. When
you depress the switch, the saw will not start until you reach
the pre-travel position. You must depress the switch fully to
activate the saw.
SPINDLE LOCK
The spindle lock allows you to secure the blade when turn-
ing the blade screw.
NOTE: Do not run circular saw with spindle lock engaged.
DUST CHUTE
To direct saw dust and chips away from the operator, a dust
chute is located on the side of the upper blade guard.
ERGONOMIC DESIGN
The design of your circular saw provides for maintaining
proper two hand control when cutting. It has been designed
to be comfortable and easy to grasp.
LASER GUIDE
The laser guide will generate a red colored line on the work
surface when turned on.
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
WARNING:
7-1/4 in. (184 mm) blade is the maximum blade capacity
of the saw. Also, never use a blade that is too thick to
allow outer blade washer to engage with the flat on the
spindle. Larger blades will come in contact with the blade
guards, while thicker blades will prevent blade screw from
securing blade on spindle. Either of these situations could
result in a serious accident.
ASSEMBLY
UNPACKING
This product requires assembly.
n Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
n Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
n Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
n If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Circular Saw with laser
7-1/4 in. (184 mm) Blade
Edge guide
Dust Nozzle Kit
Wrench
Case
Warranty Registration Card
Operator's Manual