LASER CIRCULAR SAW OPERATOR'S MANUAL CSB140LZ

ASSEMBLY

WARNING::

Current attachments and accessories available for use

with this tool are listed above. Do not use any attach-

ments or accessories not recommended by the manufac-

turer of this tool. The use of attachments or accessories

not recommended can result in serious personal injury.

EDGE GUIDE

Use the edge guide provided when making long or wide rip

cuts with the saw.

TO ASSEMBLE EDGE GUIDE

See Figure 5.

Follow these directions to assemble the edge guide.

n Unplug the saw.

n Place edge guide through holes in base as shown in the

figure.

n Adjust edge guide to the width needed.

n Tighten edge guide knob securely.

DUST NOZZLE KIT

See Figure 6.

Dust nozzle kit is provided with the saw. As shown in the

figure, the adapter fits over the dust chute which is located on

the upper blade guard.The nozzle attaches to the adapter.

NOTE: If you use the nozzle, you should always connect it

to a standard vacuum hose.

TO ATTACH DUST NOZZLE

Follow these directions to attach the dust nozzle.

n Unplug the saw.

n Lift lower blade guard.

n Orient adapter to fit into the dust chute opening on upper

blade guard.

n Secure adapter with screw provided.

n Align hole in nozzle with raised lip on adapter and snap

into place when using a vacuum hose.

Fig. 5

Fig. 6

EDGE GUIDE

KNOB

ADAPTER

RAISED

LIP

SCREW

NOZZLE

HOLE

DUST

CHUTE