OPERATOR’S MANUAL 14.4 V WORKLIGHT FL1400 BATTERIES AND CHARGERS SOLD SEPARATELY Your worklight has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Thank you for your purchase.
TABLE OF CONTENTS Introduction ..................................................................................................................................................................... 2 Warranty .......................................................................................................................................................................... 2 General Safety Rules ........................................................................................................
GENERAL SAFETY RULES IMPORTANT SAFETY INSTRUCTIONS If wrapped or in contact with fabrics, the worklight lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the worklight lens to come in contact with anything. WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. Keep light dry, clean, and free from oil and grease.
SAFETY RULES FOR CHARGER Do not let gasoline, oils, petroleum-based products, etc. come in contact with plastic parts. They contain chemicals that can damage, weaken, or destroy plastic. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. That pins on plug of extension cord are the same number, size and shape as those of plug on charger. b.
SYMBOLS Some of the following symbols may be used on this worklight. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the worklight better and safer.
OPERATION WARNING: The safe use of this product requires an understanding of the information on the tool and in this operator’s manual. Before use of this product, familiarize yourself with all operating features and safety rules. BATTERIES AND CHARGERS SOLD SEPARATELY 180° ROTATING HEAD CHARGER SWITCH TRIGGER BATTERY PACK RED LED YELLOW LED GREEN LED Fig. 3 Fig. 1 BULB REPLACEMENT Replace the bulb with the same type rated 14.4 V, 0.7 Amp. Always ask for replacement bulb number 981258003.
OPERATION LED FUNCTIONS OF CHARGER LED WILL BE ON TO INDICATE STATUS OF CHARGER AND BATTERY PACK: Normally the red LED on charger will come on. This indicates the charger is in fast charging mode. Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode.
MAINTENANCE GENERAL MAINTENANCE BATTERY PACK REMOVAL AND PREPARATION FOR RECYCLING Wipe the battery pack, flashlight, and charger with a clean, dry cloth periodically to remove any dust or debris. To preserve natural resources, please re c yc l e or di spose of ba tte ri e s properly. BATTERIES The battery pack for this worklight is equipped with nickelcadmium rechargeable batteries. Length of service from each charging will depend on the type of work you are doing.
