Use and Care Manual

ManualsBrandsRyobi ManualsDoors & WindowsUltra-Quiet Garage Door Opener with Free Fan Accessory

16 - English

ASSEMBLY

Fig. 13

Fig. 14

3/8 in. to

1/2 in.

Rail

Bottom

CENTER OF RAIL ASSEMBLY

Tighten

Loosen

ATTACHING RAIL ASSEMBLY TO GARAGE

DOOR OPERATOR

See Figures 15 - 16.

Locate the following items:

Garage Door Operator

Bracket (2)

Nut (4)

Rail Assembly

Place the garage door operator on a towel or the

packaging material with the light cover facing down.

Hold the rail assembly above the garage door operator

with arrow pointing toward the front of the operator.

Place the end rail onto the motor shaft with the channel

(open end) facing down.

Place the brackets on top of the studs, and over the end

rail. Secure in place using nuts. Tighten securely.

Fig. 15

Fig. 16

Drive

Gear

Front of Garage

Door Operator

Shaft

Nut

Turn the nut clockwise to tighten the belt and counter-

clockwise to loosen it. Adjust the nut until there is

approximately 3/8 to 1/2 in. of exposed thread showing

above it.

When properly tensioned, there should be about a

1/8 in. gap between the belt and the bottom of the rail

near the center of the rail assembly.

Bracket

Arrow

1/8 in.

Gap

Belt

Studs