Use and Care Manual

20 - English
INSTALLATION
Fig. 21
ATTACHING RAIL ASSEMBLY TO HEADER
BRACKET
See Figure 21.
Locate the following items:
Clevis Pin
Hitch Pin
Place the garage door operator on top of a prop or on the
ground with a towel or packaging material beneath it.
Angle the rail assembly so that it rests against the header
bracket.
NOTE: If a door spring or other obstruction is in the way,
have someone hold the garage door opener or help to
balance it on a raised support while you position the rail
assembly.
Align the holes in the bracket with the holes in the rail
assembly.
Insert clevis pin and secure with hitch pin.
Garage Door
Operator
Header
Bracket
Lag
Screws
Clevis
Pin
Header
Bracket
Hitch
Pin
Place the bottom edge of the header bracket on the
horizontal line and center the bracket on the center line.
Mark the holes in the bracket.
Drill 3/16 in. pilot holes and secure the bracket in place
using lag screws.
Rail
Assembly
Fig. 20