Use and Care Manual

25 - English
INSTALLATION
Fig. 33
Fig. 35
Fig. 36
Fig. 34
CONNECTING DOOR BRACKET TO CARRIAGE
(TROLLEY)
See Figures 33 - 38.
Locate the following items:
Curved Door Arm
Straight Door Arm
Clevis Pin (2)
Hitch pins (2)
Bolts
Lock Washers
Nuts
To connect sectional doors:
Lower the garage door completely.
Pull the emergency release rope down and slide carriage
(trolley) toward the garage door.
Secure straight door arm to the rear of the carriage (trolley)
using clevis pin and hitch pin.
Secure curved door arm to the door bracket using clevis
pin and hitch pin.
Bring the curved and straight arms together. Choose two
sets of aligned holes and install bolts, washers, and nuts.
NOTE: For better rigidity, install fasteners in holes that
are as far apart as possible.
NOTE: If the holes in the arm do not align, remove the
straight door arm and reattach it in the reverse position.
If the straight door arm hangs too low after assembly, you
can shorten the length of the arm by cutting off up to 6
inches.
Curved
Door Arm
Lock
Washer
Hitch Pin
Hitch Pin
Clevis Pin
Clevis
Pin
Straight
Door Arm
Bolt
Nut
Emergency
Release Rope
Carriage
(Trolley)