Use and Care Manual

26 - English
INSTALLATION
To connect single-panel doors:
Lower the garage door completely.
Pull the emergency release rope down and slide carriage
(trolley) toward the garage door.
Place the curved and straight arms together and align
the holes.
Choose two sets of aligned holes and install bolts,
washers, and nuts.
NOTE: For better rigidity, install fasteners in holes that
are as far apart as possible.
Secure straight door arm to the door bracket using clevis
pin and hitch pin.
Secure curved door arm to the rear of the carriage (trolley)
using clevis pin and hitch pin.
Fig. 37
Fig. 38
INSTALLING THE SAFETY SENSORS
See Figures 39 - 44.
Locate the following items:
Safety Sensors (2)
Insulated Staples
Wing Nut
Bracket
Screw
WARNING:
DO NOT operate the garage door opener unless the
safety sensors are installed and working correctly. Failure
to properly install and ensure that the safety sensors are
working correctly can result in death or serious personal
injury.
WARNING:
The bottom of the safety sensor should be no higher than
6 inches above the garage floor. This will ensure that the
door reverses should a child, pet, or small object move
beneath the door as it lowers. Improper placement of the
safety sensors can result in death or serious personal
injury.
WARNING:
The effectiveness of the safety sensors included in this
system directly relates to the placement and installation
of the sensors. Incorrect placement or installation could
prevent the sensors from working as intended and result
in death or serious personal injury.
Assemble the safety sensors by inserting the sensor stud
through the long slot in the bracket and securing with a
wing nut.
Lower the garage door completely.
Bolt
Nut
Hitch
Pin
Clevis
Pin
Clevis
Pin
Stud
Wing Nut
Safety
Sensor
Long
Slot
Bracket
Hitch
Pin
Fig. 39
Lock
Washer