Use and Care Manual

27 - English
Safety
Sensor
INSTALLATION
Fig. 40
Fig. 41
Position both sensors on either side of the interior of the
garage door about 4 to 6 inches above the garage floor
and point the lenses towards each other. The arrow should
be facing up.
NOTE: The bottom of the sensor should be no higher
than 6 inches above the floor.
NOTE: The receiving sensor has a green LED. Ensure that
the lens on this sensor is not exposed to direct sunlight.
Mark a hole in the bracket.
Drill 3/16 in. pilot hole and secure the bracket in place
using a screw.
NOTE: Use lag screws and concrete anchors (not
included) when installing the brackets into concrete, brick,
or other masonry.
WARNING:
To avoid the risk of death, electric shock, or serious
personal injury ensure that the garage door opener is
unpluged and the battery pack is removed before wiring
the sensors.
Safety
Sensor
Lag
Bolt
Fig. 42
Fig. 43
WARNING:
Connect the sensors using low voltage wires only to
prevent the risk of electric shock or serious personal
injury.
Route the wires from the sensors to the door sensor wire
terminals. Attach the wires to the wall and ceiling using
the insulated staples.
To install or remove wires from a wire terminal, depress
the tab beside the terminal.
Twist the striped wires from both sensors together
and insert them into either the left or right door sensor
terminal.
Safety Sensor
Wires
Insulated
Staples
Garage
Door
Operator
LED
(Green)
Safety Sensor
(Source)
Safety Sensor
(Receiver)
LED
(Red)
Arrow