Use and Care Manual

29 - English
Tabs
Back
Cover
Screw
Pencil
INSTALLATION
Cut two pieces of wire slightly longer than the measured
or estimated length.
Strip 7/16 in. of insulation from the ends of each wire.
Insert one wire into each of the keypad terminals.
Route the wires from the terminals to the desired location.
Attach the wires to the wall and ceiling using the insulated
staples.
Insert a flat head screwdriver into the tabs on the indoor
keypad and remove the back cover.
Pull the wires through the hole in the back cover.
Hold the back cover against the wall. Use a pencil and a
level to mark screw hole placement.
Mount the back cover to the wall using screws. Be careful
not to damage the wires.
Connect one wire to each of the screws on the back of
the keypad.
Fig. 48
Fig. 49
Wires
Screws
Back
Cover
Connect the key pad to the back cover.
NOTICE:
Install entrapment warning label next to the indoor
keypad in a prominent location.
For details about using the indoor keypad, see Using the
Indoor Keypad in the Operations section.
Fig. 46
Wire
Fig. 47
Entrapment
Label