Use and Care Manual

36 - English
Correct
(Fully Open Position)
Incorrect
(Fully Open Position)
Fig. 62
Fig. 63
OPERATION
NOTICE:
Do not open or close the garage door using the indoor
keypad or remotes until the travel limits have been
properly set. Doing so could cause severe damage to
the garage door or the garage door operator.
Before setting the travel limit:
Pull the emergency release rope down and manually open
the garage door until the carriage (trolley) engages the
bullet.
To set the travel limit for the open position:
Open the console door.
Press and hold the UP button for three seconds. After
you release the button, it will begin blinking and continue
blinking until the travel limit has been set.
Press and hold the UP button to move the garage door
to the open position.
For fine adjustments, press and release the UP or DOWN
buttons.
Once the door is in the open position, press the SET
button to store the travel limit. Once the travel limit is
stored, the UP button will stop blinking and and shine
continuously.
To set the travel limit for the closed position:
Open the console door.
Press and hold the DOWN button for three seconds. After
you release the button, it will begin blinking and continue
blinking until the travel limit has been set.
Press and hold the DOWN button to move the garage
door to the closed position.
For fine adjustments, press and release the UP or DOWN
buttons.
Once the door is in the closed position, press the SET
button to program the travel limit. Once the travel limit
is set, the DOWN button will stop blinking and shine
continuously.
Release
Lever
Carriage
(Trolley)
Carriage
(Trolley)
Bullet
Bullet